Peugeot 308 Key Fob Replacement
Peugeot's 308 is somewhat old-fashioned but it's still attractive. It might not be the plushest car in its class but the Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxing and civilised drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can aid in solving the issue whether it is ongoing or intermittent.
Water Damage
If you leave your key fob in a puddle or get it wet while kayaking, swimming canoeing, rafting or canyoning, it's probably to sustain water damage. The best way to prevent this from happening is to keep it in a dry bag whenever you're outside or performing activities in which the fob may be exposed to excessive amounts of water.
It's also important to make sure that the fob has dried out before you open the fob and then use it. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, it's another indication that it's been submerged in water.
A wet circuit may cause the battery's power to be depleted or even explode. If you can pull your 308 keyfob out of the water you need to turn the button side up and shake as much water as you can before opening the casing. After opening it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90-percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module issue signal interference or a malfunctioning chip. If none of the above is the cause you can restart the system by disconnecting a 12 Volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start feature that allows the driver to start the car from afar while warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial, especially in the cold winter months. Remote start systems can stop working for a variety reasons, including an inactive coin-battery.
The coin-shaped battery within the key fob may last between two and four years depending on the frequency with which it is utilized, the place it was purchased, and the way it is used. The date of use will be displayed on the packaging or in the user's manual.
If the key fob stopped working after exposure to clean tapwater, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing it. In case of exposure to salty or soapy water, the chip may be damaged and you'll need to replace the key fob completely.
If you're unsure whether the battery is damaged You can test its voltage using a multimeter attached to both the minus and plus terminals. If the voltage is less than 12-13 volts, then you should replace the battery. Alternatively, you can try to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should start.
Faulty Receiver Module
If you don't see "Key Detected" you might find that your receiver module is not working properly. It is the part which sends out an alert when your key fob turns on. It also acts as an alarm and prevents the vehicle from starting without the correct key.
This could be due to a number of factors including water damage or simply the aging process. If the electronic chip within your Peugeot 308 keyfob has been damaged due to dirty tap water It could be because the keyfob was in contact with it. In this situation, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and try again.
If the issue continues to persist, it is a good idea to consult the local Peugeot expert or locksmith. They'll utilize a diagnostic tool to help pinpoint the issue and repair it for you.
It can be a stressful experience to lose your Peugeot car key. just click the following post qualified auto locksmith will be able to solve the issue in a matter of minutes. They can program your car and cut a fresh, working key for you. Find a locksmith near you.
A malfunctioning electronic chip
The electronic chip in the Peugeot 308 key fob plays a crucial function in the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message that says "anti-theft". In this instance, the only solution is to replace the key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest time.
The chip in the key fob of your Peugeot 308 may become faulty for different reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob is exposed to soapy water, clean it immediately. You can use a paper towel and isopropyl ethanol to clean the electronic component. The battery must then be allowed to fully dry.
Radio interference can cause the key fob to stop working. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. This could be due to unsafe conditions or objects that are close to the vehicle. If you have this issue you should visit a Peugeot dealership.
The Peugeot 207/308 Key Fob is very delicate and requires particular care. It is crucial not to drop or throw the key fob. If you lose it, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Be sure to disconnect the negative first, and then the positive.